171010501 3 MagI C Power Module VDMM - Variable Step Down MicroModule 2.5V - 5.5V Input / 1A Output / 0.8V - 5.5V Output DESCRIPTION FEATURES 3 The VDMM 171010501 MagI C MicroModule Peak efficiency up to 96% provides a fully integrated DC-DC power supply Current capability up to 1A including the switching regulator IC with integrated Input voltage range: 2.5V to 5.5V MOSFETs, controller, compensation and shielded Output voltage range: 0.8V to 5.5V inductor in one package. 25A typical quiescent current Integrated shielded inductor The 171010501 offers high efficiency and delivers Low output voltage ripple: 6mV typ. up to 1A of output current. It operates with an input Output voltage accuracy over temperature: 2% max voltage from 2.5V to 5.5V and is designed for a Fixed switching frequency: 4MHz small solution size. Constant on-time control Synchronous operation The MicroModule maintains high efficiency Power good indicator throughout the output current range by automatically Undervoltage lockout transitioning between operation modes based on Internal soft-start the load demands. Thermal shutdown Short-circuit protection The 171010501 is available in an LGA-6EP Cycle-by-cycle current limit package (3.2 x 2.5 x 1.55mm). RoHS und REACh compliant Operating ambient temperature up to 85C This module has integrated protection circuitry Operating junction temp. range: -40C to 125C that guards against thermal overstress with thermal Complies with EN55032 class B radiated emissions shutdown and protects against electrical damage standard using overcurrent, short-circuit and undervoltage protections. TYPICAL APPLICATIONS General point of load power supply for low power systems Replacement of linear regulators DSP and FPGA power supply auxiliary voltages Portable instruments Battery powered equipment TYPICAL CIRCUIT DIAGRAM Data Sheet version 2.0 November 2021 www.we-online.com/powermodules 1171010501 3 MagI C Power Module VDMM - Variable Step Down MicroModule PINOUT SYMBOL NUMBER TYPE DESCRIPTION Output voltage. Place output capacitors as close as possible to VOUT VOUT 1 Power and PGND. For thermal performance, use copper plane(s) at this pin. Power good flag pin. This open drain output is pulled up if the feedback PG 2 Output voltage is greater than 95% or less than 105% of the internal reference voltage. A pull-up resistor is required if this function is used. Feedback pin. This pin must be connected to the external resistor FB 3 Input divider (between VOUT and PGND) to adjust the output voltage. Input voltage. Place the input capacitor as close as possible to VIN VIN 4 Power and PGND. Enable pin. Setting this pin high enables the device, while setting this EN 5 Input pin low shuts down the device. This pin must not be left floating. Power ground. It must be connected to the ground plane and to the PGND 6 Power thermal pad. Exposed pad. This pin is internally electrically connected to PGND. It Exposed PGND EP is recommended to connect it to the ground plane for device heat Pad dissipation. Data Sheet version 2.0 November 2021 www.we-online.com/powermodules 2