NCV47551DAJGEVB

Test Procedure for the NCV47551DAJGEVB Evaluation Board 1. Connect the test setup as is shown in Figure 1. See Table 1 with required equipment. - Letter F Force line - Letter S Sense line 2. Select output current limit by connecting jumper J J . 0 3 - J I ~ 100 A 0 LIM0 - J I ~ 10 mA 1 LIM1 - J I ~ 20 mA 2 LIM2 - J I R position available for individual current limit setting by resistor from 3 LIM3 CSO3 range 127.5 to 25.5 k 3. Set Input Voltage and turn on Power Supply. 4. Enable chip by connecting external Voltage Source on appropriate EN jumper. Enable voltage must be higher than 2.31 V. 5. Set load current (max 20 mA) and turn ON Load. 6. Monitor Output voltage, its given according to Equation 1. (eq. 1) 7. Monitor CSO voltage on appropriate CSO connector. It should be max 2.55 V in steady state. The CSO voltage is proportional to output current according to Equation 2. (eq. 2) 8. Compare your results with measured results in Table 2. 2/7/2014 1 www.onsemi.com Power Supply Load A - meter V - meter Voltage V - meter Source Figure 1. Test Setup Table 1: Required Equipment Equipment Ranges Power Supply 0 V 45 V / 100 mA Voltage Source 0 V 45 V Load 0 mA 100 mA V - meter 0 V 20 V A - meter 0 mA 100 mA 2/7/2014 2 www.onsemi.com