LIGHTING-POWER-POE-GEVB

Connected Lighting Platform Getting Started Guide Attention: The Connected Lighting Platform is powered by AC Mains, and exposed to high voltage. Only trained personnel should manipulate and operate on the system. Ensure that all boards are properly connected before powering, and that power is off before disconnecting any boards. Do not attempt re- connecting any of these boards while under operation. During operation, some surfaces may become hot the LED board can dissipate up to 55 watts. Use appropriate heat sink. The Lighting Platform is delivered with high luminous LEDs boards. Before any operation, use suitable Personal Protective Equipment (PPE) to protect the eyes. Failure to comply with appropriate safety precautions may result in personal injury or death, or equipment damage. 1. Overview The Connected Lighting Platform is a modular kit for developing a complete industrial lighting solution with power supply, LED driving system and Bluetooth Low Energy connectivity through the RSL10 Sense and Control mobile app. Figure 1. Connected Lighting Platform The following modules are available as part of the platform (LIGHTING-1-GEVK): - Dual LED driver - AC/DC power supply - Bluetooth Low Energy connectivity - LED For high-power connectivity, an IEEE 802.3bt compliant Power-Over-Ethernet (PoE) board is available separately. Features High-power lighting features o Up to 2 Strings of 16 LEDs (7000 Lumen) o Dual independent LED Channel o White balance control (12-bit Dimmer from 0 to Max) Multiple connectivity options o Bluetooth Low Energy o Power Over Ethernet (PoE) Compliant with multiple industry standards High efficiency power conversion ( >90% at full load ) 2. Prerequisites Hardware - Connected Lighting Platform (LIGHTING-1-GEVK) - J-link Ultra+ Debug Probe - AC power cord with (example here) If Using the PoE Power Module - Power Over Ethernet Power Module (LIGHTING-POWER-POE-GEVB) - PoE Power Injector (Phihong POE90U-1BT PSE) Supporting Platforms (Optional) - Energy Harvesting Bluetooth Low Energy Switch (if using the Energy Harvesting sample application) - RSL10 USB Dongle Software - Bluetooth IoT Development Kit CMSIS Pack (01.11.02 or higher) - ON Semiconductor IDE Installer - RSL10 Software Package - RSL10 Software Apps Package - RSL10 Getting Started Guide - Connected Lighting Platform FOTA Firmware (Optional) If using the RSL10 USB Dongle