MD-123 Double-Balanced Mixer, Rev. V3 10 MHz - 3 GHz Features FP-2 Usable to 4 GHz Impedance: 50 Ohms Nominal Maximum Input Power: 600 mW max. 25C, Derated linearly to 85C 3.2 mW/C IF Port Current: 50 mA Max. MIL-STD Screening Available Description Transformers convert the LO and RF paths to bal- anced lines connecting to a low barrier, Schottky diode ring quad. These transformers help provide excellent isolation between ports. Pin Configuration Pin No. Function Pin No. Function 1 GND 5 LO 2 GND 6 GND 3 GND 7 GND 4 IF 8 RF 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: MD-123 Double-Balanced Mixer, Rev. V3 10 MHz - 3 GHz 1 Electrical Specifications : T = -55C to +85C A Parameter Test Conditions Frequency Units Min Typ Max Frequency Range RF, LO Ports 0.01 - 3 GHz GHz IF Port 0.01 - 3 GHz GHz Conversion Loss dB 8.0 Isolation LO to RF 10 - 500 MHz dB 25 500 - 1000 MHz dB 30 1000 - 3000 MHz dB 25 LO to IF 10 - 500 MHz dB 20 500 - 1000 MHz dB 25 1000 - 3000 MHz dB 25 RF to IF 10 - 500 MHz dB 20 500 - 1000 MHz dB 25 1000 - 3000 MHz dB 20 DC Polarity Negative DC Offset mV 7 RF Input 1 dB Compression dBm +7 1 dB Desensitization dBm +5 SSB Noise Figure Within 1 dB of Conversion Loss Max. Typical Two Tone IM With 10 dBm input, each input 25 100 - 2000 MHz dB >56 Ratio MHz and 35 MHz IF 1. All specifications apply when operated at +10 to +13 dBm available LO power with 50 ohm source and load impedance. 2. Conversion Loss is specified for IF frequency of 10 MHz to 2 GHz. See IF port bandwidth graph. 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: