RHOTO-INTERRUPTER Part Number: KTIR0411S Package Dimensions Features z Ultra-small. z Minimal influence from stray light. z Low collector-emitter saturation voltage. z RoHS Compliant. Applications z Optical control equipment. z Cameras. z Floppy disk drives. Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the data- sheet are subject to change without prior notice. Absolute Maximum Ratings (TA=25C) Parameter Symbol Rating Unit Forward Current IF 50 mA Reverse Voltage VR 6 V Input Power Dissipation Pd 75 mW Peak Forward Current (Pulse Width <100uS,Duty Cycle=1%) IFP 1 A Collector-Emitter Voltage VCEO 35 V Emitter-Collector Voltage VECO 6 V Output Collector Current IC 20 mA Collector Power Dissipation PC 75 mW Operating Temperature Topr -25~+85 C Storage Temperature Tstg -40~+100 C Soldering Temperature (1/16 inch from body for 5 seconds) Tsol 260 C Note: 1. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAD0361 REV NO: V.6 DATE: JUL/08/2016 PAGE: 1 OF 5 APPROVED: Wynec CHECKED: Tracy Deng DRAWN: W.Q.Zhong ERP:1105000030 KingbrightElectro-optical Characteristics (Ta=25C) Parameter Symbol Conditions Min. Typ. Max. Unit Forward voltage VF I F=20mA 1.2 1.5 V Input Reverse current I R V R=5V 10 A Output Collector dark current I CEO VCE=20V 100 nA I C=1mA Collector-emitter saturation voltage VCE(sat) I F=40mA 0.4 V VCE=5V Transfer Current transfer ratio CTR 38 % I F=20mA charact- eristics Rise time t r 5 25 sec VCE=2V Response time I C=2mA R L=100 Fall time t f 4 20 sec *1 Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Fig.1 Forward Current vs. Fig.2 Collector Current vs. Forward Voltage Forward Current Fig.3 Collector Current vs. Collector-emitter Voltage SPEC NO: DSAD0361 REV NO: V.6 DATE: JUL/08/2016 PAGE: 2 OF 5 APPROVED: Wynec CHECKED: Tracy Deng DRAWN: W.Q.Zhong ERP:1105000030 Kingbright