LITIX Basic TLD1314EL 3 Channel High-Side Current Source Package PG-SSOP-14 Marking TLD1314 1 Overview Applications Exterior LED lighting applications such as tail/brake light, turn indicator, position light, side marker,... Interior LED lighting applications such as ambient lighting, interior illumination and dash board lighting. VBATT GND ISO-Pulse protection circuit Internal depending on supply OUT3 requirements Thermal Output protection control OUT2 DEN Diagnosis enable OUT1 IN SET Current adjustment Status TLD1314EL to other LITIX Basic * In case PWM via VS is performed ** For EMI improvement if required Application Diagram with TLD1314EL Data Sheet Rev. 1.2 www.infineon.com 2018-04-26 C =2.2F mod R SET C =4.7nF VS VS 470k * ST C =100pF** ST GND 4.7nF** 4.7nF** 4.7nF** LITIX Basic TLD1314EL Overview Basic Features 3 Channel device with integrated output stages (current sources), optimized to drive LEDs with output current up to 120 mA per channel Low current consumption PWM-operation supported via VS-pin Output current adjustable via external low power resistor and possibility to connect PTC resistor for LED protection during over temperature conditions Reverse polarity protection and overload protection Undervoltage detection Open load and short circuit to GND diagnosis Wide temperature range: -40C < T < 150C j PG-SSOP-14 package with exposed heatslug Description The LITIX Basic TLD1314EL is a three channel high side driver IC with integrated output stages. It is designed to control LEDs with a current up to 120 mA. In typical automotive applications the device is capable to drive i.e. 3 red LEDs per chain (total 9 LEDs) with a current up to 60 mA, which is limited by thermal cooling aspects. The output current is controlled practically independent of load and supply voltage changes. Table1 Product Summary Parameter Symbol Value Operating voltage range V 5.5 V ... 40 V S(nom) Maximum voltage V 40 V S(max) V OUTx(max) Nominal output (load) current I 60 mA when using a supply voltage range of 8 V - 18 V (e.g. OUTx(nom) Automotive car battery). Currents up to I possible in OUT(max) applications with low thermal resistance R thJA Maximum output (load) current I 120 mA depending on thermal resistance R OUTx(max) thJA 750 7% Output current accuracy at R = 12 k k SET LT Protective Functions ESD protection Under voltage lock out Over Load protection Over Temperature protection Reverse Polarity protection Diagnostic Functions Diagnosis enable function OL detection SC to Vs (indicated by OL diagnosis) SC to GND detection Data Sheet 2 Rev. 1.2 2018-04-26