AN2018-12 iMOTION Link User Manual V1.1 EN iMOTION Link User Manual iMOTION programming, debugging and tuning tool Quality requirement category: Industry Features Programming of firmware and parameters file for IMC10xT/ IMM10xT / IMC30xA / IMD11xT devices Tuning of motor parameters via virtual UART Programming and debugging application code for programmable iMOTION devices via standard SWD or Infineons SPD interface All interfaces are galvanically isolated 3.3 V output voltage to target board DC USB interface to PC for power and data Based on SEGGER J-Link Technology Supported Devices iMOTION IMC10xT iMOTION IMM10xT iMOTION IMC30xA iMOTION IMD11xT iMOTION Link will support all future iMOTION motor control ICs. For full list of supported devices, visit www.infineon.com/imotion-link Description iMOTION Link is designed to program and debug IMC10xT/ IMM10xT / IMC30xA / IMD11xT series iMOTION motor control ICs, and all future iMOTION devices on users target board (final application board) or on iMOTION evaluation boards without on-board debugger. The iMOTION Link can also be used for motor and inverter board parameter tuning via the USB to UART interface. Corresponding PC tool (MCEDesigner v2.0.0.0 or above version) which is required to use iMOTION link is available for download on the iMOTION Link User Manual iMOTION programming, debugging and tuning tool Table of contents Table of contents 1 Introduction .................................................................................................................. 3 2 iMOTION Link technical information .............................................................................. 6 2.1 Hardware description ............................................................................................................................. 6 2.2 Components placement and geometry ................................................................................................. 6 2.3 Schematics .............................................................................................................................................. 7 2.4 Bill Of Material ......................................................................................................................................... 9 3 Driver software requirements for iMOTION Link ............................................................ 10 3.1 Using iMOTION Link with MCEDesigner ............................................................................................. 10 3.2 Using iMOTION Link with standard ARM IDEs .................................................................................. 12 4 iMOTION Link Getting Started Guide ............................................................................. 13 4.1 Getting Started with MCE Designer ...................................................................................................... 13 4.1.1 Downloading MCE software for target device ................................................................................. 13 4.1.2 PC port configuration ....................................................................................................................... 13 4.1.3 Programming target device ............................................................................................................. 15 4.2 Using iMOTION Link with standard ARM IDEs .................................................................................. 17 4.2.1 PC port configuration ....................................................................................................................... 17 User Manual 2 <Revision 1.1> <2020-01-23>