SDP86XX Optoschmitt Detector FEATURES Side-looking plastic package 55 (nominal) acceptance angle Wide sensitivity ranges TTL/LSTTL/CMOS compatible Buffer (SDP8600/8601/8602) or inverting (SDP8610/8611/8612) logic available Three different lead spacing arrangements Mechanically and spectrally matched to SEP8506 and SEP8706 infrared emitting diodes INFRA--6.TIF DESCRIPTION OUTLINE DIMENSIONS in inches (mm) The SDP86XX series is a family of single chip Tolerance 3 plc decimals 0.005(0.12) Optoschmitt IC detectors molded in a side-looking black 2 plc decimals 0.020(0.51) plastic package to minimize the effect of visible ambient light. The photodetector consists of a photodiode, amplifier, voltage regulator, Schmitt trigger and an NPN output transistor with a 10 k (nominal) pull-up resistor. Output rise and fall times are independent of the rate of change of incident light. Detector sensitivity has been internally temperature compensated. Flexibility of use is enhanced by a choice of three different lead configurations in-line (SDP8601/8611), 0.05 in.(1.27mm) offset pin circle (SDP8600/8610) and 0.10 in. (2.54mm) offset center lead (SDP8602/8612). Device Polarity: Buffer - Output is HI when incident light intensity is above the turnon threshold level. Inverter - Output is LO when incident light intensity is above the turnon threshold level. DIM 028.cdr Honeywell reserves the right to make changes in order to improve design and 200 h supply the best products possible.SDP86XX Optoschmitt Detector ELECTRICAL CHARACTERISTICS PARAMETER SYMBOL MIN TYP MAX UNITS TEST CONDITIONS ABSOLUTE MAXIMUM RATINGS SCHEMATIC (25C Free-Air Temperature unless otherwise noted) Supply Voltage 12 V Duration of Output Short to V or Ground 1.0 sec Output Current 18 mA Operating Temperature Range -40C to 85C Storage Temperature Range -40C to 85C Soldering Temperature (5 sec) 240C Notes 1. Derate linearly from 25C to 5.5 V at 85C. Honeywell reserves the right to make changes in order to improve design and 201 h supply the best products possible.