NB3x6x1xxG8DFNEVK NB3x6x1xxG8DFN OmniClock Evaluation Kit Manual www.onsemi.com EVAL BOARD USERS MANUAL Devices Supported NB3H60113G (DFN8, 3.3 V) NB3V60113G (DFN8, 1.8 V) Introduction Description NB3x6x1xxG8DFNEVK is an evaluation kit offering a The NB3x6x1xxG, which is a member of the OmniClock convenient solution for evaluating DFN8 devices. Included family, is a versatile user programmable clock generator are one main board, a daughter board, and a USB cable. The designed by ON Semiconductor with customer experience main board and daughter board are 4 layer boards with in mind. These devices are tailored to fit into an extensive dedicated power and GND planes. array of applications including wearable technology, smart The daughter board plugs directly on to the main board phones, digital cameras, Ebooks, portable electronics, and using four 4pin header connectors. These connectors route Internet of Things. The NB3H designated parts are powered the signal, power and ground to the device on the daughter by 3.3 V and 2.5 V supplies while NB3V parts support 1.8 board. The two boards correctly plug into one another in V operation. only one orientation ensuring proper pin alignment. The These devices are One Time Programmable (OTP), low daughter board has a DFN8 socket to test NB3x6x1xxG power PLL based clock generators that accept fundamental devices. A view of the main board with the DFN8 daughter mode parallel resonant crystals of up to 50 MHz or a single board is shown in Figures 1 and 2. ended LVCMOS/LVTTL reference clock input of up to The Clock Cruiser Software is the GUI software 200 MHz. The outputs can be configured as either three developed to be used with this evaluation kit, and can be single ended LVCMOS/LVTTL outputs or a combination of downloaded for free from www.onsemi.com. It allows the one single ended output and one differential user to set programmable parameters and generate solutions LVPECL/LVDS/HCSL/CML output. The generated clock that fit application needs. These solutions can then be outputs frequency can range between 8 kHz to 200 MHz. programmed in to devices OTP memory or be temporarily Other programmable parameters include internal crystal written into device registers for evaluation. For more load capacitor, drive strength for LVCMOS outputs, output information on using the GUI, refer to Clock Cruiser User frequency modulation controls (type, depth, modulation Guide. rate), output phase inversion, and PLL bypass mode. The devices are fully functional between 40C to +85C. Figure 1. 45 View of Main Board with DFN8 Figure 2. Top View of Main Board with DFN8 Daughter Board Semiconductor Components Industries, LLC, 2016 1 Publication Order Number: July, 2016 Rev. 1 EVBUM2358/DNB3x6x1xxG8DFNEVK Figure 3. Main Board Figure 4. DFN8 Daughter Board www.onsemi.com 2