VECP Starter Kit Xilinx Zynq UltraScale+ ZU3EG MPSoC based on 1.2 GHz Quad Arm Cortex-A53 and 600MHz Dual Cortex-M4 Cores 4GB DDR4 SDRAM (64-bit, 2400MHz) 4GB eMMC Flash, 128MB QSPI Flash 1 x USB 3.0 Host, 1 x USB 3.0 Device, 1 x USB-UART, 2 x Gigabit Ethernets, MIPI-CSI, HDMI, TF SONY imx334 4K Sensor Ready to Run Linux OS Built-in 4k/30fps Image Signal Processing IP Core Built-in GigE Vison 2.0 IP Core Built-in Machine Vision USB3 Vision IP Core Figure 1-1 VECP Starter Kit The VECP Starter Kit is an affordable and complete Vision Edge Computing Platform to provide an excellent image processing solution for computer vision development based on Xilinx Zynq UltraScale+ ZU3EG MPSoC which features a 1.2 GHz quad-core ARM Cortex-A53 64-bit application processor, a 600MHz dual-core real- time ARM Cortex-R5 processor, a Mali400 embedded GPU and rich FPGA fabric. The kit comes with a MYD-CZU3EG- ISP development board and some necessary cable accessories to help users start their development rapidly. The MYD-CZU3EG-ISP development board is capable of handling 4K video at 30fps through the built-in ISP core and can implement ultra-low delay video transmission at maximum 0.7ms. The input videos support Bayer, YCbCr and RGB formats to meet the demand of high frame rate and high-resolution image acquisition. The image can be output through diversified image output interfaces including HDMI, Gigabit Ethernet and USB 3.0. The integrated GigE vision IP core supports Machine Vision GenICam V2.4.0 standard and user-defined XML files. The USB3 vison IP core also meets the industrial machine vision standard. 1 / 9 Figure 1-2 VECP Data Processing Frame The MYD-CZU3EG-ISP development board consists of a MYC-CZU3EG CPU Module with installed active heatsink, a base board and a SONY imx334 4K Sensor which is installed on the rear of the base board and connected to the MIPI-CSI interface through an FPC cable. From the CPU PL part, the board has extended one Gigabit Ethernet, one USB 3.0 device and one HDMI interface for image output. From the PS part, the board has extended one USB-to-UART interface, one USB 3.0 Host, one TF card slot and one Gigabit Ethernet for data communication purpose. The board is ready to run Linux operating system provided with plenty of software resources. MYIR also offer custom design services for board design based on the MYD-CZU3EG-ISP development board or customized image sensors or customized IP cores according to customers requirements. Figure 1-3 MYD-CZU3EG-ISP Development Board Top-View (delivered with installed active heatsink by default) 2 / 9