International Power Unregulated DC Power Supply IP500U48 Description The International Poweropen frame serie are a high reliability line of regulated open frame linear DC power supplies designed to operate over the wide range of AC power sources found worldwide. This feature simplifies your inventory and service consideration by allowing the use of one standard power supply regardless of destination. These models are designed to meet many domestic and international regulatory agency requirements. If you plan to distribute your products worldwide, obtaining necessary agency approvals can be greatly simplified by specifying the International Poweropen frame serie. Features VDE Transformer Construction Two Hour Burn-in 100/120/220/230-240 VAC Input Two Year Warranty OVP on 5 Volt Outputs UL Recognized for US & Canada File .05% Regulation E1333338 Remote Sense on most Outputs TUV Rheinland Licensed Industry Standard Case Size CE Marked Full Rated to 50 Degrees C Chassis notched for AC Input Foldback/Current Limit AC Input accepts .110 x .032 Fast-on Very Low Output Ripple or Solder Connection. Inherently Low Conducted & (Not available on F Case Models.) Radiated noise levels DC Output 6-32 Screw Terminals Optional General Specifications AC Input: Other outputs use optional 100/120/220/240 VAC +10%, -13%. 47- overvoltage protectors IOVP12 and 63 Hz. IOVP24. Tolerance for 230 VAC operation is Remote Sensing: +15%, -10%. See Voltage/Current Rating Charts. Derate output current 10% for 50 Hz Provided on outputs where indicated. operation. Stability: See chassis A.C. connection table for 0.3% for 24 hours after 1 hr. warm-up. jumper and line fusing requirements. Temperature Ratings DC Output: Operating: See Voltage/Current Rating Charts. 0C to 50C full rated, derated linearly Adjustment range 5% minimum. to 40% at 70C. Voltage nonadjustable on3 terminal (Recommended forced air at 200W, regulato outputs of models IHAD12 50 CFM required at 250W) and IHAD15. Storage: Line Regulation: -40C to 85C05% for a 10% line change. Temperature Coefficient: Exceptions: .01%/C typical, .03%/C maximum01% for F case models Efficiency (typical) 1% for IHAD12 and IHAD15 5V outputs:.............................45% 0.5% for all other outputs 12V and 15V outputs.............55% using 3 terminal regulators. 24V through 250V outputs...60% Load Regulation: Master/Slave Operation: .05% for a 50% load change. Provided on F case models only. For Exceptions: parallel operation of up to 6 units02% for F case models Vibration: 1% for IHAD12 and IHAD15 Random vibration from 10Hz to 2KHz, 0.5% for all other outputs 6.15grms (3 axis). using3 terminal regulators. Shock: Output Ripple: Operating 20G peak acceleration. 5 Volt to 28 Volt units: 5mV pk-pk EMI/RFI: maximum These linear power supplies have 48 Volt to 155 Volt units: .02% pk-pk inherently low conducted and maximum radiated noise levels. For most system 200 Volt & 250 Volt units: .05% pk-pk applications they will meet the maximum requirements of (FCC) 47CFR15J and 3 Terminal Regulator units: 0.2% pk-pk EN55022. maximum Safety Agency Certifications: Transient Response: UL: 1950, Third Edition Less than 50sec for a 50% load CUL: CAN/CSA C22.2 No. 950-95, change. IEC950 Short Circuit and Overload Protection: TUV Rheinland: EN 60950: 1992 + A1 + Automatic current limit/foldback. A2 + A3 + A4 + A11 Overvoltage Protection: CE Mark: LVD 73/23/EEC Provided on 5V outputs where Leakage Current & Dielectric Withstand indicated set at 6.3V 0.4V. Leakage current is less than 50A. Field terminal to terminal spacing is