Click here for production status of specific part numbers. MAX22700MAX22702 Evaluates: MAX22700DMAX22702D Evaluation Kits MAX22700EMAX22702E General Description Features The MAX22700MAX22702 evaluation kits (EV kits) 2 EV Kits to Support 3 Output Options: GNDB, Miller provide a proven design to evaluate the MAX22700 Clamp, or Adjustable UVLO MAX22702 family of single-channel isolated gate drivers 2 Input Configurations: Single-Ended with Enable, or with ultra-high common-mode transient immunity (CMTI) Differential of 300kV/s (typ). Two identical channels (devices) are 2 Identical Channels Allowing Propagation Delay included on the EV kit in order to demonstrate the very Matching Measurements tight part-to-part propagation delay matching of 2ns (max) over the -40C to +125C operating temperature range. 2 Calibration Channels for Precision Propagation Delay Measurements Two types of evaluation kits, MAX22701EVKIT and MAX22702EVKIT , are available to support variants with SMA Connectors and Terminal Blocks for Easy different B-side options, gate driver common pin GNDB Connection to External Equipment (MAX22700), Miller Clamp pin (MAX22701), and adjust- Wide Power Supply Voltage Range from 3V to 5.5V able undervoltage-lockout pin (MAX22702). In addition, (A Side) and 13V to 36V (B Side) both EV kits support variants with different A-side options, Guaranteed Up to 3kV Isolation for 60s RMS differential inputs (D versions), or a single-ended input with an enable pin (E versions). Both evaluation boards -40C to +125C Temperature Range come with the narrow-body 8-pin SOIC package type. Proven PCB Layout See Table 1 for EV kit options. Ordering Information appears at end of data sheet. The MAX22701EVKIT is fully assembled and tested, and comes populated with the MAX22701EASA+ (see Figure 1). This board also supports the MAX22701DASA+, but requires the user to replace U1 and U2. The MAX22702EVKIT is fully assembled and tested, and comes populated with the MAX22702EASA+ (see Figure 2). This board also supports the MAX22700DASA+, MAX22700EASA+, and MAX22702DASA+ if the user replaces U1, U2, and necessary external components on the B side. See Table 3 and Evaluate MAX22700 on MAX22702EVKIT section for details. The EV kits should be powered from multiple independent isolated power supplies as required by the different power domains. The A side of the MAX22700MAX22702 family has a nominal supply-voltage range from 3V to 5.5V. The B side has a nominal supply-voltage range of 13V to 36V or 6V to 36V depending upon the target device. For evalu- ating the electrical parameters of the devices without any isolation between the two sides and two devices, a common ground can be shared among different power domains. Note: When ordering an EV kit, if the desired device is not the MAX22701EASA+ or the MAX22702EASA+, request samples of the desired MAX22700MAX22702 IC that can be soldered to the PCB. 319-100462 Rev 1 3/20MAX22700MAX22702 Evaluates: MAX22700DMAX22702D Evaluation Kits MAX22700EMAX22702E Figure 1. MAX22701EVKIT Figure 2. MAX22702EVKIT Table 1. EV Kit Options EVKIT PART DEFAULT DEVICE PACKAGE TYPE POPULATED IC MAX22701EVKIT MAX22701EASA+ 8-SOIC Narrow-Body Single-Ended Inputs with Miller Clamp on side B MAX22702EVKIT MAX22702EASA+ 8-SOIC Narrow-Body Single-Ended Inputs with Adjustable UVLO on side B Maxim Integrated 2 www.maximintegrated.com